Turning Off The Power - Sony VPL-VW80 Operating Instructions Manual

Notes on input of HDMI signal
The projector adjusts the RGB dynamic range of the equipment connected with HDMI
cable to the following to suit the HDMI standard and display in best picture quality.
When video signal is input: Limited (16-235)
When computer signal is input: Full (0-255)
When a signal other than those of HDMI standard is input, the following symptoms may
occur.
• When a video signal is input, the color gradation of the dark area or bright area may
become unclear, or texts may become faded. In this case, switch the RGB dynamic range
of the connected equipment to Limited (16-235). If this adjustment is unavailable, adjust
"Brightness", "Contrast", or "Sharpness" in the Picture
pages 47, 48)
• When a computer signal is input, the texts may become faded. In this case, adjust the
"Sharpness" in the Picture

Turning Off the Power

1
Press the / (ON/STANDBY) switch.
? 1
A message "POWER OFF?" appears on the screen.
2
Press the / (ON/STANDBY) switch again before the message
? 1
disappears.
The lens protector will close. Be careful not to catch your fingers or any objects.
The ON/STANDBY indicator flashes in green and the fan continues to run to reduce the
internal heat. First, the ON/STANDBY indicator flashes quickly, during which you will
not be able to light up the ON/STANDBY indicator with the
3
Confirm that the fan stops running and the ON/STANDBY indicator lights
in red.
You can turn off the projector by holding the
second, instead of performing the above steps.
menu. (1 page 48)
/ (ON/STANDBY) switch for about 1
? 1
menu of the projector. (1
? / 1 (ON/STANDBY) switch.
31