Table of Contents
Advertisement
Symptom
ON/STANDBY flashes in
red. (A repetition rate of 5
times)
Note
When a warning indicator other than the above starts flashing, and the symptom persists even after
carrying out the above methods, consult with qualified Sony personnel.
Message Lists
Warning messages
Message
High temp.! Lamp off in 1
min.
Frequency is out of range!
Please check Input-A
Signal Sel.
Please replace the Lamp/
Filter.
Cause and Remedy
c The lens protector is not fully open. Turn the power of the
projector off and then on again. If the lens protector still does not
fully open, consult with qualified Sony personnel.
Tip
In an urgent situation, refer to the illustration below to open the lens
protector with your hands. Press the
turn the power on and operate the projector.
Cause and Remedy
c Turn off the power.
c Check to ensure that nothing is blocking the ventilation holes.
(1 page 13)
c Frequency is out of range. Input a signal that is within the
acceptable frequency range of the projector. (1 page 76)
c Set "Input-A Signal Sel." in the Setup
"Computer" when an RGB signal is input from a computer.
(1 page 54)
c It is time to replace the lamp. Replace the lamp. (1 page 69)
c Also, replace the air filter too. Restart cleaning the ventilation
holes (intake). (1 page 69)
If this message appears again after you replace the lamp and
filter, the lamp replacement process is not complete. Check the
lamp replacement process. (1 page 69)
Note
To clear this message, press any button either on the remote control
or the control panel of the projector once.
?
1
/
(ON/STANDBY) switch to
menu to
67
Hide quick links:
Advertisement
Table of Contents
