Table of Contents
Advertisement
Symptom
"Repairing" appears on the
display.
Repairing
In a case you intend to cancel the
Repairing process.
Do you want to cancel a repairing process ?
When selecting "Yes", the disc may not be
usable.
Yes
Repairing
Picture noise appears.
The unit does not play back the
tape.
Recording does not start
immediately after pressing
[VCR REC/OTR I].
The remote control does not
function.
The motor rotates even when
playback / recording is stopped.
* If the above remedies do not solve the problem, please call an authorised service centre.
Downloaded from:
http://www.usersmanualguide.com/
Troubleshooting (cont'd)
• If a power failure occurs or the mains cable is unplugged during recording,
finalising, formatting or editing (even after "Wait for a moment." message
disappeared), a repairing process will begin automatically when the unit is
turned on next time. It may take several minutes up to about four hours.
• If you intend to cancel the Repairing process, press [OPEN/CLOSE EJECT A]
on the front panel, then select "Yes" with [Cursor s / B] and press [ENTER].
After that, the disc tray will automatically open. In case the Repairing
process is cancelled, the disc MAY NOT work.
No
• Adjust tracking control for better picture by pressing [PROG.
you are playing back a video tape.
• Head cleaning for VCR may be necessary.
Refer to "AUTO HEAD CLEANING" on page 4.
• No video tape is inserted.
• Make sure the video tape has a record tab when you record to a video tape.
If needed, cover the hole with cellophane tape.
• Check if a video tape is in the unit. Press [VCR]. Then, try again.
• Check if the Child Lock is activated. (See page 10.)
• The motor may rotate for the duration of approximately 5 minutes for
efficient operation. This is not a malfunction.
Others
Remedy
DVD
VCR
/ ] while
EN
93
Advertisement
Table of Contents
