Table of Contents
Advertisement
You can also reset the time code (00:00:00:00) using the RMT-VP1K remote commander
(sold separately).
How to set the user bit (UB Preset)
1. MENU →
of the control wheel.
2. Turn the control wheel and select the first two digits.
3. Set the other digits following the same procedure as in step 2, then press
center of the control wheel.
How to reset the user bit
1. MENU →
of the control wheel.
2. Press the
(Delete) button to reset the user bit (00 00 00 00).
How to select the recording method for the time code (TC
Format)
1. MENU →
center of the control wheel.
DF:
Records the time code in Drop Frame* format.
NDF:
Records the time code in Non-Drop Frame format.
*
The time code is based on 30 frames per second. However, a gap between the actual time and the
time code will occur during extended periods of recording as the frame frequency of the NTSC image
signal is approximately 29.97 frames per second. Drop frame corrects this gap to make the time code
and actual time equal. In drop frame, the first 2 frame numbers are removed every minute except for
every tenth minute. The time code without this correction is called non-drop frame.
The setting is fixed to [NDF] when recording in 4K/24p, 1080/24p or 1080/25p.
How to select the count up format for the time code (TC Run)
1. MENU →
the control wheel.
Rec Run:
Sets the stepping mode for the time code to advance only while recording. The time code is
recorded sequentially from the last time code of the previous recording.
Free Run:
Sets the stepping mode for the time code to advance anytime, regardless of the camera
operation.
(Setup) → [TC/UB Settings] → [UB Preset], then press
(Setup) → [TC/UB Settings] → [UB Preset], then press
(Setup) → [TC/UB Settings] → [TC Format], then press
(Setup) → [TC/UB Settings] → [TC Run], then press
in the center
in the
in the center
in the
in the center of
Advertisement
Table of Contents
