Electrical Connection Of Your Hob - Sharp KH-3V19NT00-EU User Manual

• Apply the one-sided self-adhesive
sealing tape supplied all the way
round the lower edge of the cooking
surface along the outer edge of the
glass ceramic panel. Do not stretch it.
• Screw the four worktop mounting
brackets on the side walls of product

Electrical connection of your hob

• Before proceeding with the electrical
connection, verify that the current car-
rying capacity of the system and the
socket are adequate for the maximum
power rating of the hob.
• Electrical installation throughout the
residence and the electrical current
plug in use must be earthed and con-
form with safety regulations.
• If there is no dedicated hob circuit and
fused switch, they must be installed
by a qualified electrician before the
hob is connected.
• Fused switch must be easily accessi-
ble once the hob has been installed.
• Do not use adaptors, multiple sockets
and/or extension leads.
• This appliance conforms with the re-
quirements of the following EEC Di-
rectives:
1. Vitroceramic hob EEC/73/23 and
93/68, EEC/89/336 associated with
radio interference,
2. EEC/89/109 associated with contact
with foods.
• A circuit breaker with a contact open-
ing of at least 3 mm, rated 20 A and
delayed functioning type must be in-
stalled inside the supply circuit.
• For the touch=controlled vitroceram-
ic hob, the cable must be H05VV-F
3X1,5 mm² / 60227 IEC 53. You will
find the connection diagram shown on
the back of your appliance.
• During installation, please ensure that
insulated cables are used. An incor-
rect connection might damage your
appliance. The warranty will not cover
such damages.
• All repairs must be carried out by au-
thorised service personnel or a quali-
fied electrician.
• Unplug your appliance before each
maintenance. For reconnection, fol-
low the connection diagrams exactly.
Brown
EN -8-
Blue
Yellow+Green