Touch Control Safety Functions; Sensor Safety Cut Off - Sharp KH-3V19NT00-EU User Manual

dication that the key lock functionality
has been activated. Only the switch off
by operation of
switched off the appliance, you can not
restart it again without first unlocking it.
The key lock indicator will go out after
pressing for 2 sec. . Now the hob
control is unlocked and can be operated
in normal order.
TOUCH CONTROL SAFETY
FUNCTIONS
The following safety functions are avail-
able to avoid unintentionally operating
the hob control.

Sensor Safety Cut Off

, Sensor monitoring is included to pre-
vent the appliance from unwanted, ran-
dom sensor operation.
If one or more buttons are pressed
longer than 12 sec, the sensor monitor-
ing routine acoustically indicates that
wrong operation (pot or other object
placed on the button, sensor failure,
etc.) and switches off the appliance.
The safety turn-off causes the hob con-
trol to be turned off and to switch to the
S mode. An ´F` will flash in all heater
displays.
is possible. But if you
Any residual heat present will be dis-
played on all the other heater displays.
The hob control will then go into S
mode. At the same time a buzzer sig-
nal will appear. After 10 minutes, the
acoustic signalling will stop.
If erroneous operation is no longer pre-
sent, both the visual and the acoustic
signal will disappear.
Over-Temperature Switch-Off
Because the control is placed very
close to the heater in the centre front of
the hob, it can occur that an incorrectly
placed pot might be situated only half-
way on the control and not sensed by
the sensor safety cut off (not covering a
button), heats the hob up to a very high
temperature, which makes the glass
and the buttons hot enough to burn fin-
gers..
To prevent the hob control unit from be-
ing damaged, the control monitors the
temperature all the time and switches
off in case of overheating emergency. It
is indicated in the heater 4 heater dis-
play with the letter ´t` for all the time un-
til the temperature decreases.
EN -14-