Table of Contents
Advertisement
6.
Twist each of the four screws with a screwdriver just enough to attach the cooler to
the motherboard. When the four screws are attached, tighten them one by one in a
diagonal sequence to completely secure the cooler.
The cooler screws are T30 models. A torque value of 12 inch-lbf is recommended.
7.
Connect the FAN cable from the cooler to the CPU_FRNTFAN1 (CPU_FRNTFAN2 for
the second cooler) connector on the motherboard.
LCMXO2
1200UHC
PWR_CON2
IPMI_SW1
SMBUS1
SLMPCIE2
SLMPCIE6
CATERR1
CPU_FRNTFAN1
VROC_KEY1
PWR_M2
CPU_FRNTFAN1 connector
8.
Reinstall the air duct. For more information, see the section Air Duct.
2-8
SBPWR1
SYS_FAN2
Lithium Cell
CMOS Power
Super
CLRTC1
I/O
SYS_FAN1
SYS_FAN5
ISATA2
ISATA1
BUZZ1
ICS
ME_RCVR1
DIMMTRIP1
PCH_MFG1
SLMPCIE1
GPU_FAN6
GPU_FAN7
ICS
SLMPCIE10
SLMPCIE9
SLMPCIE5
GPU_FAN2
CPU1
OMNIP1
PCIE11
VGA_SW1
DM_IP_SEL1
SYS_FAN4
ASPEED
AST2500
TPM1
OCUUSB1
REARIO1
VGA_HDR1
BMCLED1
BMC_EN1
GPU_FAN9
Intel
®
SLMPCIE18
SLMPCIE17
C621
GPU_FAN8
GPU_FAN4
SLMPCIE22
SLMPCIE21
GPU_FAN3
MSD1
Z11PG-D24
CPU2
CPU_FRNTFAN2
BPPWR1
OMNIP2
COM1
AUX_PANEL2
VPP_I2C1
CPU_FRNTFAN2 connector
PSUSMB1
DM_LAN1
PWR2
SYS_FAN3
PWR1
INTRUSION1
OCUPCIE13
GPU_FAN10
OCULAN1
GPU_FAN5
OCUPCIE14
Chapter 2: Hardware Setup
Advertisement
Table of Contents
