Table of Contents
Advertisement
ESC4000 G4X
1.
Remove the storage device cage.
Refer to section ESC4000 G4X under 2.4.1 Installing the 3.5-inch SATA/SAS storage
device for the steps on removing the storage device cage.
2.
Prepare the SATA/SAS/NVME storage
device and the bundled set of screws.
3.
Place the SATA/SAS/NVME storage
device into the storage device cage (A),
then secure it using four (4) screws (B).
4.
Connect the SATA and power cable to
your SATA/SAS/NVME storage device.
OR
(optional) Connect the NVME cable to
your NVME device.
The NVME cable is optional, for more
information about the optional NVME
cable, please visit www.asus.com/
support.
5.
Replace the storage device cage.
Refer to section ESC4000 G4X under 2.4.1 Installing the 3.5-inch SATA/SAS storage
device for the steps on replacing the storage device cage.
6.
Repeat steps 1 to 6 to install the other SATA/SAS/NVME storage device.
2-20
OR
(optional)
Chapter 2: Hardware Setup
Advertisement
Table of Contents
