General Error; 1 . Alarm And Prompt Facility - Haier XShuai HXS-C3 Product Manual

7.General Error

7.1 Alarm and Prompt Facility
1. If the machine stops working, the display will show the error code.
2.Please check the display failure prompt, according to the following tips to clear the exception.
Error Code
Obstacles on the sensors
E1
window.
Obstacles on the sensors
E2
window.
E3 Driving wheel off the ground
1.Driving wheel block.
E4
2.Hair and a strip of cloth twine
in the wheels.
1.The Side brush while blocking.
E5
2.Hair and a strip of cloth twine
in the Side brush.
1.Can not work
E6
2.Cannot automatically charge.
E7
The battery is not connected.
E8 The battery is damaged.
Mechanical induction bar are
E9
stuck.
7.2 General Error
No.
1
Walk back all the time
2
XSmart does not work
3
Unable to auto-recharge
4
Unable to recharge
Product website: xshuairobot.com
Faults performance
Faults
1. It is better to avoid robot working in the strong bright environment.
2. It is better to avoid robot working in the black carpet.
3. Check the ground sensors to see if any dust or dirt covered the sensor
window.
1. Check whether the power switch is on.
2. Check whether XSmart is enough power, if not, please charge the XSmart.
1. Check whether the LED indicator of docking station is on.
2. Check whether there are obstacles between XSmart and recharging station.
3. When the battery power is low, please charge XSmart artificially.
1. Check if the battery is installed correctly. If yes,please turn on the power
switch to see if the display is on.
2.If the appearance of the battery is deformed, damaged and so on, please
stop using XSmart and call our customer servicer.
Solution
Clean the ground detection
sensor.
Clean the Wall detection
sensor.
Place the machine on the
ground.
Please check and clean the
debris on the driving wheel.
Please check the hair and cloth
wrapped around the side brush.
Charge the XSmart manually.
Connect the battery cable.
Battery replacement.
Check the mechanical induction
bar.
Solution
- 18 -
Remarks
Clean the ground detection
sensors regularly.
Clean the wall detection
sensors regularly.
Keep the machine on the
ground.
Clean the wheels regularly.
Clean the Side brush
regularly.
Please keep XSmart
charging after working
everytime.