Epson OT-WH30 Installation Manual page 5

4. Attach the bracket using the included two screws.
CAUTION
❏ The screws to be used differ depending on the printer. See Precautions.
❏ Make sure to tighten the screws completely. If they are not fully tightened, the
bracket and printer may fall or fall over, causing injury or an accident.
Q
NOTE
TM-L100 allows you to attach the bracket without removing the rubber feet.
5. Peel off the stickers from the spacers, and attach them as shown
below.
CAUTION
Make sure that the surface of the printer is clean and dry.
English
OT-WH30 Installation Manual 5