If You Think Something Has Gone Wrong - Mitsubishi Electric Jet Towel JT-SB216JSH2-H-NE Instruction Manual

If you think something has gone wrong

Perform the following checks and fixes.
Problem
No air blows even if
hands are inserted
Air does not stop
Stops operating
during hand drying
Air is cold
Air does not
warm up
The lamp does not light
up even when the ground-
fault circuit interrupter on.
The display section
lamp flashes
Crack-like shapes can be
seen around the nozzle
The operating sound is too
loud (Air blow is too strong)
I want to reduce power consumption
(want to turn off the heater)
(Only for JT-SB216JSH2 model)
Check
Are any lamps in the display on?
Has a blackout occurred?
Are you putting your hands in all the way?
Was the ground-fault circuit interrupter turned on while
your hands or an object was inside the hand drying area?
Is the sensor blocked by dirt or dust?
Is the black wall area in the hand drying area white with dirt?
Has the dryer been used continually for
more than 30 seconds?
Are any lamps in the display flashing?
The heater lamp is off.
(Only for JT-SB216JSH2 type)
Air conditioning is not working.
Check the model name of the product.
Is the room temperature too high?
Has a blackout occurred?
The ground fault circuit interrupter is
"OFF".
This may flash if there is a malfunction
in the power supply.
There is no unevenness, even when touched by hand.
(No feeling of cracking)
Contact your dealer for any changes
to settings or adjustments etc.
Costs are as agreed with the dealer.
If the above fixes do not work, turn off the ground-fault circuit interrupter, and have your dealer
inspect and if necessary repair the appliance. (Costs are as agreed with the dealer.)
Turn the ground-fault circuit interrupter on.
Place your hands all the way inside the hand drying area.
Turn the ground-fault circuit interrupter "OFF", and
when the display lamps all go out, remove any
foreign substances or dirt. Wait for at least 1 minute
after turning the ground-fault circuit interrupter
"OFF", and then turn it back "ON" again.
If the hand dryer is used continually for more than 30 seconds,
the power lamp flashes, and the dryer automatically stops.
To continue using the hand dryer, remove your hands, and
then re-insert them.
Contact the dealer about any changes to the
settings. Costs are as agreed with the dealer.
The air may not feel warm if the room temperature is less than
18 ºC .
(The JT-SB216KSN2 type is not equipped with a simple heater)
The JT-SB216KSN2 model is not equipped with an
internal heater, and therefore hot air does not blow.
If the room temperature is above 30 º C, the heater will stop
working to prevent the temperature from rising too high.
Turn the ground-fault circuit interrupter on.
Turn the ground-fault circuit interrupter "OFF", check that all
of the lamps on the display section are off, and then wait for 1
minute before switching ground-fault circuit interrupter back "ON".
This pattern occurs when the product is molded (manufactured).
It does not affect product performance, and is not a malfunction.
Cautions
− 8 −
Fix
Do not attempt to modify or
disassemble this appliance yourself.