Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZCG61236XA
Summary of Contents for Zanussi ZCG61236XA
- Page 1 User Manual Cooker ZCG61236XA...
-
Page 2: Table Of Contents
Children shall not carry out cleaning and user maintenance of • the appliance without supervision. General Safety Only a qualified person must install this appliance and replace • the cable. This appliance is intended for use up to an altitude of 2000 m • above sea level. www.zanussi.com... - Page 3 Ensure that the appliance is switched off before replacing the • lamp to avoid the possibility of electric shock. If the mains power supply cable is damaged, it must be • replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. www.zanussi.com...
-
Page 4: Safety Instructions
• All gas connections should be made by a WARNING! qualified person. Risk of fire and electrical shock. • Before installation, make sure that the local • All electrical connections should be made by distribution conditions (nature of the gas and a qualified electrician. www.zanussi.com... - Page 5 WARNING! the door. Risk of injury, fire, or damage to the • Open the appliance door carefully. The use appliance. of ingredients with alcohol can cause a mixture of alcohol and air. • Before maintenance, deactivate the appliance. www.zanussi.com...
- Page 6 • Keep the lid glass open, while the oven is in operation (if applicable). Internal light • The type of light bulb or halogen lamp used for this appliance is only for household appliances. Do not use it for house lighting. www.zanussi.com...
-
Page 7: Product Description
For coffee makers and small pans. • Turnspit For roasting larger joints of meat and poultry. • Storage compartment The storage compartment is below the oven cavity. To use the compartment, lift the lower front door then pull it down. www.zanussi.com... -
Page 8: Before First Use
• For manual ignition put the flame near the try to light the burner again after burner. Push the knob for the hob down and minimum 1 minute. turn it counterclockwise to the maximum gas flow position www.zanussi.com... -
Page 9: Hob - Hints And Tips
Hob - Care and cleaning General information WARNING! Refer to Safety chapters. • Clean the hob after each use. • Always use cookware with clean bottom. www.zanussi.com... -
Page 10: Oven - Daily Use
Range of temperature adjustment. 240°C Grilling To grill flat food in the middle of the grill. To make toast. Oven lamp To illuminate the oven interior. To use this function, press the button for the lamp. Turnspit To spit roasting meat. www.zanussi.com... - Page 11 1. Open the oven door. 3. At the same time push the knob for the 2. Ignite the grill burner. oven functions and turn it counterclockwise to the maximum gas flow position. www.zanussi.com...
-
Page 12: Oven - Clock Functions
The turnspit and the grill This prevents the heat from are hot. There is a risk of burns. circulating around the tray. The food may be burnt, especially in the rear part of the tray. www.zanussi.com... -
Page 13: Oven - Hints And Tips
This is normal. quality and quantity of the Always stand back from the appliance when ingredients used. you open the appliance door while cooking. To decrease the condensation, operate the appliance for 10 minutes before cooking. www.zanussi.com... - Page 14 70 - 80 Macaroni 1.5 - 2.5 55 - 60 min. 10 - 15 65 - 75 oven Kebab Ha- 1.5 - 2.5 30 - 35 max. 10 - 15 40 - 50 1) Preheat the oven for 10 minutes. www.zanussi.com...
- Page 15 5 - 10 30 - 35 Thick 1.4 - 1.5 25 - 30 min. 10 - 15 35 - 45 Calzone 1.4 - 1.5 30 - 35 min. 5 - 10 40 - 45 1) Preheat the oven for 10 minutes. www.zanussi.com...
-
Page 16: Oven - Care And Cleaning
Quantity (kg) Grill position Time (min) Shelf position Sheep on skewer 1.5 - 2.0 max. 100 - 120 Turnspit Chicken on skew- 1.2 - 1.8 max. 100 - 110 Turnspit Oven - Care and cleaning WARNING! Refer to Safety chapters. www.zanussi.com... - Page 17 The oven door can close if you try to from the side wall and remove it. remove the internal panel of glass when the door is still assembled. Do not lose the screws. 1. Open the door fully and hold the two door hinges. www.zanussi.com...
-
Page 18: Troubleshooting
3. Replace the lamp with a suitable 300 °C the top edge of the door. Lift the inner door. heat-resistant lamp. 4. Install the glass cover. Troubleshooting WARNING! Refer to Safety chapters. www.zanussi.com... - Page 19 The rating plate is on the front If you cannot find a solution to the problem frame of the appliance cavity. Do not remove yourself, contact your dealer or an Authorised the rating plate from the appliance cavity. Service Centre. www.zanussi.com...
-
Page 20: Installation
For minimal distances for fitting check the table. Voltage 220 - 240 V Frequency 50 / 60 Hz Appliance class Dimension Height 850 - 870 Width Depth Other technical data Appliance category: II2H3B/P LPG: G30 (3B/P) 28-30 mbar Natural Gas: G20 (2H) 20 mbar www.zanussi.com... - Page 21 Use a fixed connections or use a flexible stainless steel pipes in compliance with the regulation in force. If you use flexible metallic pipes, make sure they do not come in touch with mobile parts and they are not squeezed. www.zanussi.com...
- Page 22 To check the seal use a soap solution, not a flame. 4. Replace injectors with the ones necessary for the type of gas you use. The gas supply ramp is on the rear side of the control panel. www.zanussi.com...
- Page 23 1. Fully tighten the bypass screw. 2. Put the knob back. Changing from liquid gas to natural gas 1. Unscrew approximately one turn the bypass screw position A. 2. Put the knob for the hob back. 3. Connect the appliance to the electricity. www.zanussi.com...
- Page 24 Changing from natural gas to liquid gas 1. Fully tighten the bypass screw. 2. Put the knob back. 3. Connect the appliance to the electricity. Changing from liquid gas to natural gas www.zanussi.com...
- Page 25 3. Put the appliance on the sidewall on a clean and smooth surface. Place each foot into a separate hole, in the plinth, and rotate it clockwise. 2. Release the burner injector with a 7 mm socket spanner and replace it with a right one. www.zanussi.com...
- Page 26 Return the product to your the packaging in applicable containers to local recycling facility or contact your municipal recycle it. Help protect the environment and office. human health and to recycle waste of electrical and electronic appliances. Do not dispose www.zanussi.com...
- Page 27 www.zanussi.com...
- Page 28 www.zanussi.com/shop...