Boutside Back Exhaust; Preparing The Rear Wall For Outside Back Exhaust - GE JVM3162RJSS Installation Instructions Manual

B
OUTSIDE BACK EXHAUST
INSTALLATION
OVERVIEW
B1. Prepare Rear Wall
B2. Attach Exhaust Adaptor to
Wall Plate
B3. Attach Mounting Plate
to Wall
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Oven
PREPARING THE REAR
B1.
WALL FOR OUTSIDE BACK
EXHAUST
You need to cut an opening in the rear wall for
outside exhaust.
Read the instructions on the REAR WALL
1
TEMPLATE.
2 Tape it to the rear wall, lining up with the holes
previously drilled for holes A and B in the wall plate.
Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
3
31-7000173 Rev. 0
Installation Instructions
(Horizontal Duct)
ATTACH THE EXHAUST
B2.
ADAPTOR TO THE OVEN REAR
PANEL
Unscrew and remove the exhaust adaptor
1
assembly from the top of the oven. Remove the
cover plate installed on the back.
Attach the exhaust adaptor to the oven rear
2
panel by sliding it into the guides at the top
center of the back of the oven.
Exhaust Adaptor
Guide
Push in securely until it is in the lower locking tabs.
Take care to assure the damper hinge is installed so
that it is at the top and that the damper swings freely.
Exhaust
Adaptor
Cover Plate
Damper
(hinge side up)
Guide
Locking
Tabs
33