Descaling The Nanocloud Rotary Humidification Wick - Philips AC2729/90 User Manual

Note
• Make sure that the pre-filter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-filter.
5
After the pre-filter is completely dry,
place it back into the back panel
(fig. h).
6
Touch and hold
reset the pre-filter cleaning time.
Descaling the NanoCloud
rotary humidification
wick
Filter alert light
status
F0 displays on the
screen and wick&
pre-filter cleaning
alert goes on
1
Pull out the water tank (fig. j).
2
Lift the water tray upwards and pull
it out horizontally (fig. k).
3
Take the wick wheel off the wick
support (fig. †).
4
Soak the NanoCloud rotary
humidification wick in cleansing
agent (e.g diluted white vinegar,
Citric acid solution) for two hours
(fig. ˆ).
for 3 seconds to
Follow this
Descale the
NanoCloud
rotary
humidification
wick
Note
• Please use mid or acid cleanser
• White vinegar (5% acetic acid)
mix with equal amount of water
• 24g citric acid mix with 4L
water
• If there are white deposits
(limescale) on the filter, make
sure that the side with the white
deposits is immersed in the water.
• Do not take the NanoCloud rotary
humidification wick off the wheel
during descaling.
5
Rinse the NanoCloud rotary
humidificationwick under the tap
to rinse away vinegar or citric acid
residues. During rinsing, turn the
wick so that both front and back are
rinsed (fig. ‰).
6
Air dry the NanoCloud rotary
humidification wick (fig. Š).
Note
• Do not put the NanoCloud rotary
humidification wick under direct
sunlight.
7
Touch and hold
to reset the NanoCloud rotary
humidification wick cleaning time.
for 3 seconds
EN
15