Troubleshooting - AEG ADT2304 User Manual

Hide thumbs Also See for ADT2304:
Table of Contents

Advertisement

Available languages

Available languages

84
www.aeg.com
8. Set the temperature regulator to
obtain the maximum coldness and
run the appliance for three hours
using this setting.
Only after this time put the food back into
the freezer compartment.
7.5 Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
The appliance does not op‐
erate.
The appliance is noisy.
The compressor operates
continually.
1. Disconnect the appliance from
electricity supply.
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all
accessories.
5. Leave the doors open to prevent
unpleasant smells.
Possible cause
The appliance is switched
off.
The mains plug is not con‐
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not suppor‐
ted properly.
Temperature is set incorrect‐
ly.
Many food products were
put in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor‐
rectly.
The Super Freeze function is
switched on.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock‐
et. Contact a qualified elec‐
trician.
Check if the appliance
stands stable.
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature
again.
Refer to "Installation" chap‐
ter.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door"
section.
Refer to "Super Freeze func‐
tion" section.

Advertisement

Table of Contents
loading

Table of Contents