Toshiba B-EP800-CHG-QM-R Owner's Manual page 8

CE Compliance (for EU only)
This product complies with the requirements of EMC Directive including their
amendments.
CE marking is the responsibility of TOSHIBA TEC GERMANY IMAGING
SYSTEMS GmbH, Carl-Schurz-Str. 7, 41460 Neuss, Germany.
For a copy of the related CE Declaration of Conformity, please contact your
dealer or TOSHIBA TEC.
NOTES:
1.This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
2. Changes or modification not expressly approved by manufacturer for compliance
could void the user's authority to operate the equipment.
"This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations. "
"Cet appareil numérique de la classe B respecte toutes les exigences du
Règlement sur lematériel brouilleur du Canada."
NOTICE FOR THE CUSTOMERS IN THE UNITED KINGDOM
A moulded plug complying with BS 1363 is fitted to this equipment for your safety and
convenience.
Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by
ASTA or BSI to BS 1362, (i.e., marked with
If the plug supplied with this equipment has a detachable fuse cover, be sure to attach
the fuse cover after you change the fuse. Never use the plug without the fuse cover. If
you should lose the fuse cover, please contact your nearest TOSHIBA TEC service
representative.
or mark) must be used.
7
(for CANADA only)