Base Enclosure - HP 530 Maintenance And Service Manual

Base enclosure

Description
Base enclosure
Rubber Feet Kit
Before removing the base enclosure, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Memory/WLAN module compartment cover (see
b.
Optical drive (see
c.
Switch cover (see
d.
Keyboard (see
e.
Display assembly (see
f.
Remove the base enclosure:
Release the ZIF connector (1) to which the TouchPad cable is attached, and disconnect the TouchPad
1.
cable (2) from the system board.
Turn the computer upside down, with the front toward you.
2.
52 Chapter 4 Removal and replacement procedures
Battery on page 32).
Hard drive on page 33)
Optical drive on page
Switch cover on page
Keyboard on page 43)
Display assembly on page
Memory module on page
39)
41)
47)
Spare part number
441625-001
438557-001
35)