Setting The Audio Input Level (Input Level); Low-Cut Filter Setting (Lcf); Power Save Setting (Power Save); Setting The Battery Type (Battery Type) - Sony DWTP01N/14 Operating Instructions Manual

Setting the audio input level
LEVEL)
You can set the input level to an analog head amp.
Select LINE or MIC, depending on the audio source
connected to the audio input connector.
Input Attenuation (dB)
MIC 0
3
6
9
3 dB steps
45
48
LINE –
MIC/LINE settings and attenuator settings for the audio input level can be changed from the receiver and other devices
via the wireless remote control function.
For details on wireless remote control function, see "Using the Cross Remote" on page 7.
Low-cut filter setting
The frequency of the low-cut filter can be set.
OFF: Turns off the low-cut filter.
20 30 40 50 60 70 80 90 100 120 140 160 180
200 220 (Hz): Low-cut filter is set according to the
selected frequency.
Using wireless remote control, this function can be
controlled from the receiver and other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 7.
Power save setting
To conserve power, this setting allows you to put all
transmitter functions to sleep.
ACTIVE: The transmitter operates normally.
SLEEP: The sleep function is on. During sleep, the
POWER indicator flashes at 2-second intervals.
To change back to normal operation
During sleep, press the SET, +, or – button.
You can also use the wireless remote control to change the
receiver back to normal operation.
For details on wireless remote control function, see
"Using the Cross Remote" on page 7.
(INPUT
Reference input level (dBu)
–58
–55
–52
–49
3 dB steps
–13
–10
+4
(LCF)
(POWER SAVE)
When MIC is selected, ATT (attenuation level) will flash
next. With the microphone connected, speak into the
microphone as you monitor the audio input level meter and
press the + or – button repeatedly to select the appropriate
attenuation level.
The reference levels for the various settings are as follows:
Maximum input level (dBu)
–22
–19
–16
–13
3 dB steps
+23
+24
+24
Note
If the transmitter is turned off while SLEEP is selected, the
setting will return to ACTIVE (normal operation)
automatically.
Setting the battery type
TYPE)
Set this item according to the type of batteries you use to
obtain accurate battery power status indication.
TYPE1: The power status is indicated based on
characteristics of new LR6 (size AA) Sony Alkaline
batteries. Select this for LR6 (size AA) alkaline batteries.
TYPE2: Select this for rechargeable nickel-metal-hydride
batteries with capacities of about 2000 mAh.
TYPE3: Select this for lithium batteries.
TYPE4: Select this for rechargeable nickel-metal-hydride
batteries with capacities of about 2500 mAh.
Note
The characteristics of batteries change according to battery
type and environmental conditions. It is recommended that
you learn the characteristics of batteries you use before
using them.
Displaying the accumulated use time
(TIME)
You can display the accumulated battery use time as a
rough estimate of total transmitter usage.
The factory setting is "00:00".
12
Headroom (dB)
36
34
20
(BATTERY