3. Remove the charger board (Section 5.18).
4. Disconnect the speaker cable 1 from the system board
(Figure 5-38).
5. Swing the battery bay support bracket 2 to the right until it
clears the right edge of the speaker assembly.
6. Lift the front edge of the speaker assembly until it rests at an
angle 3 .
7. Slide the speaker assembly forward and remove it 4 from the
base enclosure.
Figure 5-38. Removing the Speaker Assembly
Reverse the preceding procedures to install the speaker assembly.
Maintenance and Service Guide
Removal and Replacement Procedures
5–49