Mass Storage Devices - HP Mini 1000 Maintenance And Service Manual

Mass storage devices

NOTE: Each hard drive spare part kit and solid-state drive spare part kit includes a cable and bracket.
Description
8-GB solid-state drive
16-GB solid-state drive
60-GB, 4200-rpm hard drive
Before removing the hard drive or solid-state drive, follow these steps:
1. Shut down the device. If you are unsure whether the device is off or in Hibernation, turn the device
on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the device.
3. Disconnect the power from the device by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the device.
4. Remove the battery (see
5. Remove the keyboard (see
To remove the hard drive:
1. Release the ZIF connector (1) to which the USB board pass-through cable is attached. The cable
lies across the top of the hard drive.
2. Disconnect the USB board pass-through cable (2), and then detach the tape from the top of the
hard drive.
3. Release the low insertion force (LIF) connector (1) to which the hard drive cable is attached, and
then disconnect the cable (2).
Battery on page 32).
Keyboard on page 35).
Spare part number
507313-001
507314-001
504601-001
Component replacement procedures 37