Hard Drive - HP Mini 210-1010 Maintenance And Service Manual

Hard drive

NOTE: Each hard drive spare part kit includes a cable adapter, bracket, and four rubber isolators.
Description
Hard drive:
320-GB, 7200-RPM
250-GB, 7200-RPM
160-GB, 7200-RPM
Hard Drive Hardware Kit
Before removing a hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service cover (see
Remove the hard drive:
1. Disconnect the hard drive cable (1) from the system board.
2. Use the Mylar tab (2) on the right side of the hard drive to lift the right side of the drive (3) until it
rests at an angle.
Battery on page 38).
Battery on page 38).
Component replacement procedures
Spare part number
590819-001
589670-001
589667-001
589673-001
41