System Configuration Menu
Select
Language Support
Processor C4 State
Boot Options
Diagnostics Menu
Select
Hard Disk Self Test (select models only)
Memory Test
To do this
Change the Setup Utility language.
Enable/disable the processor C4 standby state.
Set the following boot options:
●
f10
and
f12
Delay (sec.)―Set the delay for the
f12
functions of Setup Utility in intervals of 5 seconds
each (0, 5, 10, 15, 20).
●
HP QuickWeb―Enable/disable the QuickWeb Boot
menu in Setup Utility.
●
Internal Network Adapter boot―Enable/disable boot
from Internal Network Adapter.
●
Boot Device Priority―Set the boot device priority for:
◦
Internal hard drive (select models only)
◦
USB Floppy
◦
USB CD/DVD ROM Drive
◦
USB flash drive
◦
USB Hard drive
◦
USB Card Reader
◦
Network adapter
NOTE:
Only the devices attached to the system
will appear in the boot order menu.
To do this
Run a comprehensive self-test on the hard drive.
Run a diagnostic test on the system memory.
f10
and
Setup Utility Menus
73