Mounting (For Trained Installers) - NEC E438 User Manual

Mounting (for Trained Installers)

Carefully inspect the location where the unit is to be mounted. Not all walls or ceilings are capable of supporting the weight of
the monitor.
The weight of this monitor is provided in the specifications.
The product warranty does not cover damage caused by improper installation, re-modeling, or natural disasters.
Failure to comply with these recommendations could result in voiding the warranty.
Pay attention not to obstruct the air vents with the mounting brackets.
Mounting bracket

ARNINNN::
Please refer to the


• When using commercially-available mounting brackets, make sure that they
comply with the VESA Flat Display Mounting Interface Standard (FDMI).
• Check that the surface where the brackets will be attached is strong enough.
• Choose commercially-available mounting brackets strong enough to support the
weight of the monitor.
• Prior to mounting, inspect the installation location to ensure that it is strong
enough to guaranty safety.
• Pay attention not to obstruct part of the air vents of the monitor with the brackets.
• For detailed information, refer to the instructions included with the mounting
equipment.
• There are 4 installation holes on the back. Mount the monitor evenly at the four
locations.
(See "Mounting on Walls or Ceilings" for recommended installation examples.)
• Use screws of the sizes mentioned below to fix the brackets to the monitor. Tighten the screws securely.
(A)
E328
E438
E498 M6
E558
E658
NOTEN: When used in a video wall configuration for a long time, a slight expansion of the monitors may happen due to


temperature changes. It is recommended that a gap of over one millimeter is kept between adjacent monitor
edges.
"Important Information"
Screw Size
(B)
13-15 mm
section.
Bracket Hole No Thread
(C)
≤ Ø 8.5 mm
> 1.0 mm
English - 15
Monitor
No thread (D)
Diameter (C)
Recommended Fasten
(D)
2.3 mm
4 mm 390-520 N•cm
4.5 mm
Gap
Mounting
bracket
Washers
Screw (A)
Thickness of
(B)
the bracket
and washers
Force