Table of Contents
Advertisement
Chapter 2
Installing the Subscriber Unit
3
9
Figure 2: Mounting the Subscriber Unit to a Wall or Tower
1. Subscriber Unit 2. Mounting Kit 3. Wall Holder/Pole Mount 4. M8 × 25 mm Hex Screw 5. M8 Spring Washer 6. M8 Flat
Washer 7. M8 Nut 8. M5 Flat Washer 9. NS 1/4" × 1/2" HEX Chipboard Screw 10. Wall Anchor
2.
Liberally apply an anti-corrosion spray to all galvanized steel components, including mounting brackets,
washers and screws.
3.
Select a mounting location on the wall.
4.
Place the mounting bracket on the wall and mark four mounting holes.
5.
Drill four holes and insert a wall anchor into each hole.
6.
Secure the mounting bracket to the wall with four 1/4" × 1/2" HEX screws, four spring washers, and four flat
washers.
7.
Connect the arm bracket to the mounting bracket using a screw, spring washer, flat washer and nut. Make
sure the nut is hand tight
8.
Connect the subscriber unit to the arm bracket using a screw, spring washer, flat washer and nut. Make sure
the nut is hand tight.
9.
Make sure the subscriber unit is properly grounded according to local standards. For more information, refer
to
Section 2.6, "Grounding the Subscriber
10. Tighten the screws connecting the arm bracket to the subscriber unit and mounting bracket. Make sure the
screws are torqued to 24 N·m (17.7 ft. lb.).
10
10
2
8
4
5
6
Unit".
7
5
Mounting the Subscriber Unit to a Wall or Tower
RUGGEDCOM WIN5158-V-GPS
Installation Guide
1
2
6
Advertisement
Table of Contents
