Levelling The Appliance - LG S3WF Owner's Manual

Moving the Appliance
Use the wheels at the bottom of the appliance to
a
move the appliance. Push the appliance slowly
from about halfway down the front side.
CAUTION
• Keep the appliance upright when moving it. If
you lay the appliance on its side, refrigerant may
leak and cause the appliance to malfunction.

Levelling the Appliance

Checking the Level
Levelling the appliance prevents unnecessary
noise, vibration and movement. Check whether the
appliance is perfectly level after installation.
Adjusting and Levelling the
appliance
WARNING
• The appliance is heavy. Two or more people are
required when levelling the appliance. Failure to
follow this warning can cause serious injury or
death.
1
Position the appliance in the final location and
check to make sure it is level.
• All levelling feet must rest solidly on the
floor. Gently push on the corners of the
appliance to make sure that it does not rock
from corner to corner. Make sure there are
no gaps between the front levelling feet and
the floor.
2
Use the wrench (packaged with the appliance)
to turn the levelling feet.
• Unscrew the front feet to raise the appliance
or screw in the feet to lower it. If unable to
level the appliance using only the front feet,
install the two rear levelling feet by tipping
the appliance. Do not lay the appliance down
to install the levelling feet.
• Raise or lower the appliance using the
levelling feet until the appliance is level from
side to side and front to back.
CAUTION
• Make sure that all levelling feet are in firm
contact with the floor. If the appliance is used
without levelling, it may fall, causing injury,
damage, or product malfunction.
• Adjust the levelling feet only as far as necessary
to level the appliance. Extending the levelling
feet more than necessary can cause the
appliance to vibrate.
3
When the appliance is completely stable and all
levelling feet are resting solidly on the floor,
tighten the locking nuts
Reversing the door
It is possible to reverse the direction of the door
swing. This should be done by the installer at the
time of installation, if desired.
INSTALLATION
.
a
15