Vertical Steam; Energy Saving "Eco" Button - Bosch TDS4570GB Operating Instructions Manual

Vertical steam

This can be used to remove creases from
hanging clothes, curtains etc.
It cannot be used on a synthetic setting for
delicate items.
Warning!:
• Never direct the steam jet at garments that
are being worn.
• Never aim the steam at people or animals.
1. Set the temperature to the
2. Hold the iron in an upright position 15 cm away
from the garment being steamed.
3. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing
the iron in a vertical position and pressing the
steam release button (13 or 14*).
Energy saving
"eco" button
If the "Energy saving" button (7) is switched on,
you can save up to 25% of the energy and 40% of
the water consumption (*), and still achieve good
results when ironing most of your garments.
It is advisable to use the normal energy setting
only for thick and very wrinkled fabrics.
(*) In comparison to the maximum setting.
Note:
If you work with the "Energy saving" function,
the variable steam regulation and temperature
regulation can still be used as recommended.
"secure" auto shut-off
(model dependent)
If during ironing, the steam release button (13-
14*) on the iron handle is not pressed for a certain
length of time (8 minutes), the steam station will
automatically switch off.
The " " icon will flash when auto shut-off
has been activated.
To switch the steam station back on, press the
steam release button again.
* Model dependent
(D) Fabric protection soleplate cover (E)
(model dependent)
The fabric-protection soleplate cover (17*) is used
for steam ironing delicate garments at maximum
temperature without damaging them. Use of the
soleplate cover also does away with the need for
a cloth to prevent shine on dark materials.
It is advisable to first iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place the
setting.
tip of the iron into the end of the soleplate cover
and pull the elastic strap over the lower rear of
the iron until it fits tightly. To release the soleplate
cover, pull the elastic strap and remove the iron.
The fabric-protection soleplate cover may be
purcha sed from customer service or from our
website:
Accessory code
Descaling the filter
and the boiler (F)
(Calc'n'Clean)
To extend the life of your steam generator and to
avoid any build up of scale, it is essential that you
rinse out the filter (12) and the boiler after a period
of use (approximately after 50 hours). If the water
is hard, increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
If the "
boiler must be rinsed. Please proceed as follows:
1. Check carefully that the appliance is cold and
unplugged for more than 2 hours, and that the
water tank (1) is empty.
2. Fix the iron to the base by inserting the tip
of the iron into the front slot and moving the
secureLock lever (10) against the heel of the
iron.
3. Place your appliance over a sink or bucket.
4. Lean the appliance on the opposite side of the
filter opening.
5. Unscrew the filter (12) and take it out.
6. To wash the filter, you may:
Name of accessory
(After-sales) (Online shop)
571510
" icon flashes, this indicates that the
en
TDZ2045