Guarantee Conditions - Bosch TDS4570GB Operating Instructions Manual

Problem
Loss of pressure
during ironing.
Water spots appear
on the garment during
ironing.
Water spots appear
on the garment during
use of the "Pulse
steam" function.
The hose gets hot
during use.
Water leakage from
the boiler.
The iron does not stop
steaming after placing
it on the pad (2).
If the above does not solve the problem, get in touch with an authorised technical service.

Guarantee conditions

The terms of the guarantee for this appliance are in
accordance with that stated by our representative
for the country in which it is sold.
The details of these conditions can be obtained
from the retailer from whom the appliance
was purchased. The purchase receipt must be
presented when making any claims against the
terms of this guarantee.
You can download this manual from the local homepages of Bosch.
Possible causes
Steam release button has been
activated for too long a period
of time, that is, it has been
pressed too frequently.
May be caused by steam
condensed on the ironing
board.
Water spots are caused by
steam condensation in the hose
when cooling down after use.
This is normal. It is caused by
the steam passing through the
hose during steam ironing.
Filter (12) located at the side of
the appliance is loose.
"Pulse steam" function has
been activated by double click.
Solution
Use the steam release button at
intervals. This improves the ironing
result as the textiles will be steamed
dried and ironed properly.
Wipe the textile cover of the ironing
board, and iron any water drops to
dry them.
Water drops stop coming out of
the soleplate after using the "Pulse
steam" function for some time.
Place the hose on the opposite side
so that you cannot touch the hose
during ironing.
Tighten up the filter.
Just press the trigger once again and
the iron will stop steaming at once.
en
13