Advertisement
Installation
Technical data
– Delivery includes: dryer, installation and instruction manual.
– Check dryer for transport damage.
– The dryer is very heavy. Do not lift without assistance.
– Be careful to avoid sharp edges.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
– Do not install in a room which is susceptible to frost. Water may cause damage once it starts
to freeze.
– If in doubt, have the appliance connected by a specialist.
Setting up the dryer
Remove all accessories from
1.
the drum. The drum must be
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean,
empty.
level and firm surface.
– Do not obstruct the air inlet on the front of the dryer.
– Keep the area around the dryer clean.
– Level the dryer using the front threaded feet.
On no account remove the threaded feet.
Do not install the dryer behind a door or a sliding
door which could obstruct the door of the dryer or
prevent it from being opened. Children can then
Clean and level
not be trapped inside and their life endangered.
Make sure that the air
inlet remains unobstructed
Mains connection
For safety instructions,
see page 11.
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
– The mains voltage must be the same as the voltage specified on the rating plate
(
see page 9).
– The connected load and necessary fuse protection are specified on the rating plate.
Changing the power input
Ensure that the socket is fused.
3.
10 A
16 A
or
Set to Off
Press and hold the
Gentle
To change the power input,
Set to Off
press the
Easy Iron
button and turn the programme
Optional accessories
selector once to the right.
button.
Do not operate the dryer if there
Frost protection / Transport
is a danger of frost.
WTZ
11311
Preparation
Empty the container for condensation
see page 4.
There may be residual water in the dryer.
This can leak out if the dryer is at an angle.
8
7
What to do if ...
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales
Dimensions (DxWxH)
60 x 60 x 85 cm
service. We will always find an appropriate solution and will avoid unnecessary visits by
Weight
approximately 35 kg
engineers. Trust the expertise of the manufacturer and rest assured that the repair will be
carried out by trained service technicians using original spare parts. The contact details
Max. capacity
7 kg
of your local after-sales service can be found in the enclosed after-sales service directory,
Condensate container
approx. 4.2 l
or by calling one of these numbers:
– GB 0344 892 8979 (Calls charged at local or mobile rate.)
Ambient temperature
5 - 35 °C
– IE 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.)
Connection voltage
220 - 240 V
When contacting the after-sales service, please quote the appliance's product number
(E no.) and production number (FD) (see the inside of the door).
Connected load
2025 / 2600 W
Set the programme selector to Off and remove the appliance plug from the socket.
Fuse protection
16 A / 10 A
Start/Stop indicator lamp
does not light up.
Product number
Production number
Rating plate or inside of the door
Container empty
Clean
/
indicator lights up.
You can find the rating plate on the back of the dryer.
Container empty
Consumption rates
Specifications are average values established under normal
Clean
/
indicator light
operating conditions. Fluctuations of up to 10 % are possible.
flashes.
Spin speed in rpm
Drying time** in
Energy
Dryer does not start.
(residual moisture)
min incl. 8 min
consumption**
cooling time
in kWh
Cottons 7 kg
10 A
16 A
10 A
16 A
Programme terminated shortly
. Cupboard / Cupboard Dry * 1400
(approx. 50 %)
98
90
3.32
3.32
after the start.
1000
(approx. 60 %)
117
106
3.92
3.92
Water is leaking out.
800
(approx. 70 %)
138
120
4.48
4.48
The door opens by itself.
Iron Dry *
1400
(approx. 50 %)
76
66
2.45
2.45
The required degree of dryness
1000
(approx. 60 %)
91
82
2.94
2.94
was not achieved or the drying
time was too long.
800
(approx. 70 %)
106
96
3.43
3.43
Synthetics 3.5 kg
. Cupboard / Cupboard Dry *
800
(approx. 40 %)
42
40
1.16
1.16
600
(approx. 50 %)
53
45
1.45
1.45
*Test programmes according to DIN EN 61121.
**The values may diverge from those specified depending on over and undervoltage, fabric
type, composition of the laundry to be dried, residual moisture in the fabric and the amount
of the load.
Laundry damp.
(order from the after-sales service using the order number, depending on model)
The humidity in the room has
increased significantly.
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. The dryer must be fastened on the washing machine with this connection set.
One or more indicator lights are
If the worktop of the washing machine is less than 544 mm deep, please consult
flashing.
the after-sales service or your specialist retailer.
Power failure.
9
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
– in rooms inside the house.
dryer...
– use for drying fabrics.
The dryer
– be used for other purposes than those described above.
must
– be modified in terms of its technology or attributes.
NEVER...
Dangers
– The dryer must not be used by children or persons who have not been instructed
in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from the pockets of garments.
Pay particular attention to cigarette lighters
Mains plug plugged in?
– Do not lean or sit on the door
Programme selected?
– Open the door with care. Hot steam may escape.
/
Empty container for condensation
see page 4.
Installation
– Fasten down loose leads
– Do not operate the dryer where there is a risk of frost.
Mains
– Connect the dryer according to specifications to an AC earthed socket, as
/
Clean the fluff filter under running water
see page 4.
connection
otherwise it cannot be guaranteed that the appliance is completely safe.
Clean the air cooler, if required
see page 6.
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
Has the
Start/Stop button been pressed?
– The appliance plug and socket must be compatible.
Door closed?
– Do not use multiple plugs/couplings and/or extension cables.
Programme set?
– Do not touch or hold the appliance plug with wet hands
– Never pull the appliance plug out of the socket by its cable.
Ambient temperature greater than 5 °C?
– Do not damage the mains lead
Operation
– Only load the drum with items of laundry.
Make sure the dryer is level.
Check what has been loaded before switching the dryer on.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
Push the door closed until you hear it engage.
grease or paint (e.g. hair setting spray, nail polish remover, stain remover, cleaning
solvent, etc.)
fire/explosion hazard.
Clean the fluff filter under running water
see page 4.
– The tumble dryer is not to be used if industrial chemicals have been used for
Empty the container for condensation.
cleaning
Ambient temperature higher than 35 °C
ventilate
– Hazard due to dust (e.g. coal dust, flour): do not use the dryer
of explosion.
the room.
– Do not turn off the dryer until the drying process ends, unless the laundry will be
Air inlet may be blocked
clear obstruction.
removed quickly and spread out, so that the heat can dissipate
Unsuitable programme selected?
see page 7.
– Do not put laundry containing foamed material/rubber in the dryer
Dryer installed too closely to other objects? Provide
material may be destroyed and the dryer may be damaged due to possible
adequate air circulation.
deformation of the foamed material.
Mains failure
Restart the dryer.
– Light things, such as long hair, may be sucked into the air inlet of the dryer
Fine layer of limescale on the moisture sensors. Clean
of injury.
the sensors
see page 6.
– Final part of a tumble dryer cycle occurs without heat (cool down cycle), to ensure
that the items are left at a temperature that ensures that the items will not be
Use the next drying programme up or use the timed
damaged
programme as a supplement
see page 7.
– Switch off the dryer once the programme has ended.
Warm laundry feels damper than it really is!
– The exterior of the appliance's rear panel becomes very hot during
operation. Never touch the hot surface of the appliance's rear panel.
Make sure the room is sufficiently ventilated.
Keep children away from the appliance
Air inlet blocked?
Clear obstruction.
– The water from condensation is not drinking water and may be
Make sure that the air cooler is inserted.
contaminated with fluff.
Clean the fluff filter and air cooler
see page 4/6.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Check the installation conditions
see page 8.
Repairs must only be carried out by the after-sales service.
Switch off, allow to cool, switch back on and restart the
– Do not use the dryer with a faulty mains cable. In order to avoid risk, have the
programme.
mains lead replaced only by our after-sales service.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Remove laundry from the dryer immediately and spread
out. This allows the heat to dissipate. Be careful as the
Disposal
– Dryer: pull out the mains plug, then cut the mains cable from the appliance.
door, the drum and the laundry may be hot.
Dispose of the appliance at a public disposal facility.
– Packaging: Do not allow children access to items of packaging
of suffocation.
– All materials are environmentally friendly and reusable.
Dispose of in an environmentally responsible manner.
10
risk of explosion.
risk of tipping.
risk of tripping.
risk of electric shock.
risk of electric shock.
risk
elastic
Risk
Dryer
WTC84100IN
Risk of burns!
en Instruction manual
risk
11
Advertisement
