Table of Contents
Advertisement
StarBoard FX-79E2/89WE2
2. How to Use
2.1 Basic Operations
This chapter gives a description of the basic operations of the board.
2.1.1 Character Input
To input characters, use your finger or the stylus that was provided with the product.
NOTICE
Do not scrape or strike the board surface by stylus pen.
Failure to comply may result in damage on the board surface.
Use an input tool with a thickness of least 10 mm.
When inputting to this product, use a tool that is at least 10 mm. If a pen or similar
tool with a thickness of less than 10 mm is used, the input will be unstable.
Also, do not use tools with a sharp tip, such as a ballpoint pen. If such a tool is used
incorrectly, it could damage the surface of the board.
- Using the stylus pen
Use the pen on the board with your body kept sufficiently away, so that your palm and
elbow do not touch the board. If your hand or elbow touches the board, or you are within 1
cm of the board, it might cause an incorrect operation.
2-1
How to use
English
Advertisement
Table of Contents
