Replacing The Front Port Panel - Bosch DIVAR IP DIP-73GC-16HD Installation Manual

36 en | Maintenance
To replace the DVD-ROM drive:
1.
2.
3.
4.
5.
6.
7.
10.7

Replacing the front port panel

To replace the front port panel:
1.
2.
3.
4.
5.
6.
2021.10 | V02 | DOC
1
1 DVD-ROM
Turn off the unit and if necessary, remove the unit from the rack.
Remove the chassis cover.
Unplug the drives power and data cables from the motherboard and/or backplane.
Locate the locking tab at the rear (on the left when viewed from front) of the DVD-ROM
drive. Push the tab toward the drive and push the drive unit out the front of the chassis.
Insert the new drive unit in the slot until the tab locks in place.
Reconnect the data and power cables.
Replace the chassis cover. replace the unit in the rack, if necessary, then turn on the
system.
Turn off and unplug the unit.
Remove the chassis cover.
Disconnect the power and data cables from the front port panel to other chassis
components including the motherboard and backplane.
Remove the old port panel by depressing the release tab, then pulling the unit out of the
chassis.
Insert the new front port panel unit in the slot until the tab locks into place.
Connect the data and power cables to the backplane and motherboard.
1
1 DVD-ROM
2
2
Installation manual
DIVAR IP all-in-one 7000 3U
2
Front port panel
2
Front port panel
Bosch Security Systems B.V.