Replacing The Fron Port Panel; Installing The Motherboard - Bosch DIP-7384-8HD Installation Manual

DIVAR IP all-in-one 7000 2U
To replace the DVD-ROM drive:
1.
2.
3.
4.
5.
6.
7.
10.7

Replacing the fron port panel

If you must install a new or replace a damaged front port panel, observe the following
instructions.
To replace the front port panel:
1.
2.
3.
4.
5.
6.
10.8

Installing the motherboard

Motherboard problems will be handled by trained support people only.
Bosch Security Systems B.V.
1 DVD-ROM
Turn off the unit and if necessary, remove the unit from the rack.
Remove the chassis cover.
Unplug the drives power and data cables from the motherboard and/or backplane.
Locate the locking tab at the rear (on the left when viewed from front) of the DVD-ROM
drive. Push the tab toward the drive and push the drive unit out the front of the chassis.
Insert the new drive unit in the slot until the tab locks in place.
Reconnect the data and power cables.
Replace the chassis cover. replace the unit in the rack, if necessary, then turn on the
system.
1 DVD-ROM
Turn off and unplug the unit.
Remove the chassis cover.
Disconnect the power and data cables from the front port panel to other chassis
components including the motherboard and backplane.
Remove the old port panel by depressing the release tab, then pulling the unit out of the
chassis.
Insert the new front port panel unit in the slot until the tab locks into place.
Connect the data and power cables to the backplane and motherboard.
1
2
1
2
Installation manual
Maintenance | en
2
Front port panel
2
Front port panel
35
2020.11 | V1.1 | DOC