5-1. MECHANICAL ADJUSTMENT
Perform the following steps before carrying out adjustments.
1. Turn ON the power of the unit, set disc to disc table No. 92, and
perform chucking.
2. Turn OFF the power.
3. Remove the case.
4. While pressing the STOP button, turn ON the POWER button.
The test mode is set.
5. The POWER button LED starts blinking.
(Test mode)
NOTE 1: The cam will start rotating when the GROUP 1 or GROUP
5 button is pressed continuously in the test mode.
NOTE 2: If the power cannot be supplied, the cam can be rotated by
rotating the pulley with your finger.
SECTION 5
ADJUSTMENTS
POWER
POWER button
GROUP 1
button
GROUP 5
button
— 16 —
LED
STOP button
GROUP 1 button
Cam
GROUP 5 button
Pulley