Removing The Roll From The Printer - Canon imagePROGRAF iPF825 Basic Guide No.2 Basic Manual

Error Message
Top cover is open.
ERROR Exxx-xxxx (x represents
a letter or number)
Sheet printing is selected.
Regular printing is selected, but
a roll is loaded.
Sheet removed.
End of paper feed.
Cause
The printer has detected that the
Top Cover is open.
An error requiring service may
have occurred.
You have attempted to print a test
print sheet or other printer status
information on a sheet, but no
sheet is loaded.
A print job for printing on sheets
was sent when a roll is loaded.
You are using a roll with the Media
Take-up Unit , but a print job
requiring sheets was sent.
A sheet has come out of the printer
during printing.
You are pressing the ▲ button on
the Control Panel and trying to
rewind the roll to the edge.
35
Corrective Action
Open the Top Cover fully, remove any foreign objects,
and close the Top Cover again.
If the error occurs again, close the Top Cover , turn off
the printer, and wait a while before restoring power.
Write down the error code and message, turn off the
printer, and contact your Canon dealer for assistance.
Load a sheet and try printing again.
To print on a roll instead, hold down the Stop button
for more than a second to cancel printing, load a roll,
and then print.
(→"Loading and Printing on Rolls," User Manual)
Hold down the Stop button for a second or more to
cancel printing.
Remove the roll and load a sheet of the type and size
of paper you have specified in the printer driver.
(→

, Removing the Roll from the Printer)

(→"Loading and Printing on Sheets," User Manual)
1. Press the Stop button for a second to cancel the
job involving sheets.
2. Choose Paper Cutting in the menu.
3. Press the Load/Eject button and remove the roll.
4. Load a sheet and resend the print job.
1. Lift the Release Lever and remove the paper.
2. If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
Release the ▲ button.
Error Messages