Store Accessories In The Pockets; Responding To Messages - Canon imagePROGRAF iPF825 Setup Manual

10
Close the Top Cover .
12
On the Roll 1 (Upper) Type screen (on the iPF815, the Roll
Media Type screen), press ▲ or ▼ to select the type of paper
loaded, and then press the OK button.
To identify the type of paper, refer to the label on the box of
sample paper. Select HW Coated for heavyweight coated paper
or Coated Paper for regular coated paper.
Printhead alignment starts automatically.
This process takes about six minutes.
When the process is complete, Online is displayed.
You are now fi nished loading the roll.

Store Accessories in the Pockets

1
Store the 3-Inch Paper Core
Attachment and other accessories in
the accessory pocket.

Responding to Messages

Error messages may appear on the Display Screen of the Control Panel during printer installation in some cases. If so, it may not indicate a problem with the
printer, and the issue may be easily resolved. Common messages and the causes are listed here with corrective actions. To respond to error messages other than
these, refer to the provided Basic Guide (2). For other detailed printer instructions, refer to the User's Guide on the User Manuals CD-ROM.
Message
The paper is loaded crooked. Lift the
release lever.
No ink tank loaded.
Insert the maintenance cartridge.
Turn off printer, wait, then turn on
again.
Paper cutting failed. Lift the release
lever.
No printhead
Hardware error. xxxxxxxx-xxxx
ERROR Exxx-xxxx
(x represents a letter or number.)
11
Press the OK button.
The paper is now advanced.
2
Use the manual pocket to store the Basic Guide (which includes descriptions of basic
printer operations, routine maintenance, and troubleshooting tips), so you can refer to it as
needed.
Cause
Paper has been loaded askew.
There is no Ink Tank of the indicated color in the
printer.
The Maintenance Cartridge is not installed.
Fastening tape or the Belt Stopper has not been
removed inside the Top Cover .
For some reason, the paper could not be cut.
The Printhead is not installed.
Another kind of error has occurred.
An error requiring service may have occurred.
16
OK
• If the message The paper is loaded crooked. Lift the release
lever. is displayed, lift the Release Lever, open the Top
MEMO
Cover, and align the right edge of the roll parallel to the Paper
Alignment Line.
1. Lift the Release Lever and open the Top Cover.
2. Align the right edge of the roll paper parallel to the right Paper
Alignment Line.
3. Lower the Release Lever and close the Top Cover.
Load or reload the Ink Tank .
(See steps 1-8 on page 6-7.)
Install the Maintenance Cartridge .
1. Turn the printer off.
2. Open the Top Cover and remove the tape or Belt Stopper .
(See step 3 on page 4.)
3. Turn the printer on.
Refer to the provided Basic Guide (2).
Reinstall the Printhead . (See steps 1-10 on page 5-6.)
Turn off the printer and wait at least three seconds before restoring
the power. If the message is still displayed after this, write down
the error code and message, turn off the printer, and contact your
Canon dealer for assistance.
Write down the error code and message, turn off the printer, and
contact your Canon dealer for assistance.
After loading a roll, the printer
automatically shows a menu for selection
of the paper type on the Display Screen
and beeps.
Corrective Action