Canon PIXMA MP150 User Manual page 90

Photo all-in-one printer
Hide thumbs Also See for PIXMA MP150:
Table of Contents

Advertisement

Message
CHECK INK
U161
U162
CHECK INK
U140
CHECK PRINTER
If the ON/OFF Lamp (green) and Alarm Lamp (orange) flash alternately,
Note
disconnect the USB cable from the machine, and then turn the machine OFF
and then unplug the machine from the power supply for a while. Plug the
machine back in and turn the machine back ON.
If the problem remains, contact a Canon service representative.
<E> and <error code> are alternately displayed on the LED of MP150.
Message
E, 2
E, 3
E, 4
E, 5
E, 7
E, 8
88
Troubleshooting
This FINE Cartridge may have previously been used, or the ink may have
run out. The function for detecting the remaining ink level will be disabled
since the remaining ink level cannot be correctly detected. If you want to
continue printing without this function, press [OK]. Canon recommends to
use new genuine Canon Cartridges in order to obtain optimum qualities.
The FINE Cartridge may not be the compatible with this machine. Install
the appropriate FINE Cartridge. If lines are misaligned or the resulting
output is not satisfactory, carry out the FINE Cartridge Alignment.
An error requiring servicing might have occurred. Turn OFF the machine,
and unplug the power cord of the machine from the power supply. After a
while, plug the power cord of the machine back in and turn ON the
machine. If the same error occurs, contact a Canon service representative.
Reload the paper correctly and press [Black] or [Color].
If paper has jammed in the machine, clear the jam, reload the paper in the
machine correctly and then press [Black] or [Color].
The ink may have run out. Replace the FINE Cartridge, and close the
Scanning Unit. If lines are misaligned or the resulting output is not
satisfactory, carry out the FINE Cartridge Alignment. If printing is in
progress and you want to continue printing, press [Black] or [Color]. Then
printing can continue under the ink out condition with the FINE Cartridge
installed. Replace the empty FINE Cartridge immediately after the printing.
The resulting print quality is not satisfactory, if printing is continued under
the ink out condition.
The FINE Cartridge may not be installed properly, or the Cartridge may not
be the compatible with this machine. Install the appropriate FINE
Cartridge. If lines are misaligned or the resulting output is not satisfactory,
carry out the FINE Cartridge Alignment.
Some FINE Cartridges are not installed in place. Install the FINE
Cartridges in the appropriate positions.
Waste ink absorber is almost full. Ink used for cleaning is absorbed in a
waste ink absorber placed in the machine. <E, 8> indicates that the waste
ink absorber is nearly full. Press [Black] or [Color] to cancel the error so
that you can continue printing. If this error occurs, replacement of the
waste ink absorber and maintenance of the machine are required. Canon
recommends to contact a Canon service representative as soon as
possible. Once the waste ink absorber becomes completely full, printing
cannot be done until the waste ink absorber is replaced.
Action
Action
Chapter 10

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pixma mp1700575b002

Table of Contents