HP Compaq Presario,Presario S5100 Support Manual page 9

UK Compliance Information
This modem is approved, by the Secretary of State at the
Department of Trade and Industry, for connection to a
single exchange line of the public switch telephone
network run by certain licensed public telecommunication
operators or systems connected thereto. (Direct exchange
lines only, not shared service or 1–1 carrier systems.)
This modem is also suitable for connection to Private
Automatic Branch Exchanges (PABXs) which return
secondary proceed indication.
If this modem is to be used with a PBX which returns
secondary proceed indication, no more than two pauses of
four seconds duration each should be inserted between the
initial PSTN access digit and the number to be dialled. This
is to avoid interference to the PTO network.
If this modem is to be used with a PBX which has extension
wiring owned by BT, connection of the modem to the
PBX can only be carried out by BT or by the authorised
maintainer of the PBX, unless the authorised maintainer
has been given 14 days written notice that the connection is
to be made by another person, and that period of notice has
expired.
This modem is suitable for use only on telephone lines
provided with Loop-Disconnect or Multi-Frequency
Dialling facilities.
Users of this modem are advised that the approval is for
connection to the PSTN via the telephone line interface
supplied with it. Connection of a modem to the PSTN by
any other means will invalidate the approval.
There is no guarantee of correct working in all
circumstances. Any difficulties should be referred to your
supplier.
Some network operators require that intended users of
their network request permission to connect and for the
installation of an appropriate socket.
Ringer Equivalence Number
The ringer equivalence number (REN) of this modem is 1.
REN is a guide to the maximum number of apparatuses
that can be simultaneously connected to one telephone line.
The REN value of each apparatus is added together, and
should not exceed 4. Unless otherwise marked, a telephone
can be assumed to have a REN value of 1.
Approved Usage
This modem is approved only for the following:
•
Storage of telephone numbers for retrieval by a
predetermined code
•
Detection of initial proceed indication
•
Automatic calling/Automatic answering
•
Tone detection
•
Operation in the absence as a secondary proceed
indication
•
Loudspeaker facility
This modem is NOT suitable for use as an extension to a
payphone.
This modem is not approved for connection to UK private
speechband services.
This modem does not support the automatic redial
function.
Any other usage will invalidate the approval of your
modem, if, as a result, it then ceases to conform to the
standards against which approval was granted.
The approval of this modem is INVALIDATED if the
apparatus is subject to modification in any material way
not authorised by the BABT, or if it is used with
or connected to external software that has not been
formally accepted by BABT.
Storage of Numbers
It is advisable to check the telephone numbers stored in
your modem immediately after programming.
In order to prevent the misdirection of class and network
interference, please ensure that all manually programmed
telephone numbers are correctly entered.
The number you enter to dial may optionally contain a
PAUSE character (a comma) to allow this modem to
operate with a PABX. Each comma gives a two-second
delay.
9