Philips DPTV565 AA Service Manual page 78

EN 78 8. DPTV565 AA
– WARM DRIVE BLUE: "-6"
15.Press the MENU button to return to the SAM menu. Exit the
Service mode by turning the set "off".
8.5 Option Settings
8.5.1 Introduction
The microprocessor communicates with a large number of I2C
ICs in the set. To ensure good communication and to make
digital diagnosis possible, the microprocessor has to know
which ICs to address. The presence / absence of these specific
ICs (or functions) is made known by the option codes.
Notes:
• After changing the option(s), save them with the STORE
command.
• The new option setting is only active after the TV is
switched "off" and "on" again with the Mains switch (the
EAROM is then read again).
8.5.2 Dealer Options
Table 8-4 Dealer options
Menu
name Subjects
Personal Picture Mute Yes
Options
Virgin Mode Yes
Auto Store
Mode
TXT
Preference
8.5.3 Service Options
Table 8-5 Service options
Menu
name Dual screen
Service Video repro
Options
Miscellaneous Tuner Type
Opt. No.
Alignments
Option
s Physically in set
Picture mute active in
case no picture detected
No Noise in case of no picture
detected
TV starts up once with
language selection menu
after mains switch on for
the first time (virgin mode)
No TV does not starts up
once with language
selection menu after
mains switch on for the
first time (virgin mode)
None Autostore mode disabled
(not in installation menu)
PDC- Autostore mode via ATS
VPS (PDC/VPS) enabled
TXT Autostore mode via ACI
page enabled
PDC- Autostore mode via ACI or
VPS- ATS enabled
TXT
TOP Preference to TOP
Teletext
FLOF Preference to FLOF
Teletext
TXT/EPG Dual
Screen Yes/No
Lightsensor Yes/No
2D Combfilter Yes/No
Pixel Plus Yes/No
TEDE9/
UV1316
Group 1
Group 2
8.5.4 Option Codes
Enter the Service Alignment Mode (SAM) by pressing the
following key sequence on the remote control transmitter:
0-6-2-5-9-6-[i+]. Do not allow the display to time out while
entering the key sequence.
Cursor to the OPT. NO. in the SERVICE OPTIONS level.
Locate the "option code label" on the inside right panel of the
unit and enter the correct codes for the model being serviced.
Example
• Group 1: 49483 32801 33055 32793
• Group 2: 39897 32768 32768 00000
Note: Remember to cursor to the STORE OPTIONS level and
select "OK" to save these changes