Toro Greensmaster 120-9600 Installation Instructions

High Height-of-Cut Kit
Greensmaster
Model No. 120-9600
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
1. Disengage the drives, lower the reels, set the parking
brake, and stop the engine before adjusting the rollers.
2. Loosen the screws securing the front roller shaft to the
height-of-cut arms
3. Remove the front roller
4. Remove the plow bolts, washers and nuts securing the
height-of-cut arms to the cutting unit side plate
1).
5. Remove the height-of-cut arms.
6. Remove the adjusting screws from the height-of-cut
arms (Figure 1).
1. Height-of-cut arm
2. Plow bolt, washer, and
flange nut
7. Apply an anti-seize lubricant to the threads of the
adjusting screws. Thread the screws into the new
height-of-cut arms.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® DPA Reel Mowers
(Figure 1).
(Figure 1).
Figure 1
3. Adjusting screw
4. Screw
Register at www.Toro.com.
8. Loosely mount the height-of-cut arms to the cutting
unit side plates with the plow bolts, washers, and nuts
previously removed.
9. Install the roller into the height-of-cut arms.
10. Center the roller between the height-of-cut arms.
Install and tighten the new screws securing the roller
shaft to the height-of-cut arms.
(Figure
11. Remove the screws and nuts securing the rear roller
brackets and spacers to the side plate mounting flanges
(Figure
1. Spacers
2. Side plate mounting flange
g017167
Note: Older Flex 21 cutting units do not have a side
plate mounting flange
the kit is being installed on an older model unit and
discard the spacers.
Form No. 3390-822 Rev A
Installation Instructions
2). Discard the screws and nuts.
Figure 2
3. Rear roller bracket
(Figure 2). Skip steps
Original Instructions (EN) All Rights Reserved *3390-822* A
Printed in the USA
g017200
11-14 if