Canon VarioPrint 6000 Series Operation Manual page 282

Load light-weight media into the paper module
Remove the light-weight media tool when there is no light-weight media loaded in the tray.
Place the light-weight media tool in the storage location in the door of the paper module.
• Make sure that the grain direction of the media is in the transport direction of the printer.
When needed, determine the grain direction, see
media on page 287
• The humidity of the light-weight media is very important
• Do not use media that is not wrapped, or not wrapped well.
• Unpack one ream and load the media before you load another ream.
• Load media as soon as possible after unpacking.
Do not use media that was stored outside the printer for more than 2 hours.
• Make sure that the correct media is assigned to the correct paper tray.
Procedure
Action
1 Open the paper tray via the schedule, the trays
view or the button on the control panel of the
paper module. Only one tray can be open at
the same time.
2 Remove the current stack from the tray.
Only remove the current stack when you load
different media in the tray.
282 Chapter 11 - Media handling
Determine the grain direction of light-weight
Turn the knob counterclockwise to move
the side sliders away from the loaded
stack.
Squeeze the green handle of the front
slider to move the trailer-edge sliders
away from the stack.
Remove the stack.
4
VarioPrint 6000 line