Manual Operation; Wi-Fi Configuration - LG LGES-5048 User Manual

03 MANUAL OPERATION

3.1 Wi-Fi Configuration

This part shows configuration on web page. You can also complete the configuration with LGES
PV Master App. Wi-Fi configuration is absolutely necessary for online monitoring and maintenance.
Preparation:
1. The inverter must be powered up with battery or grid power.
2. A router with internet access to the website
1
1. Connect Solar-Wi-Fi* to your PC or smart
phone (* its name is the last 8 characters of the
inverter's serial number); Password:12345678.
2. Open your browser and logon to
10.10.100.253 Admin (User): admin;
3. Password: admin.
4. Then click "OK".
2
1. Click "Start Setup" to choose your router.
2. Then click "Next".
Device information
Firmware version
MAC address
Wireless AP mode
SSID
IP address
Wireless STA mode
Router SSID
Encryption method
Encryption algorithm
Router Password
Cannot join the network, may be caused by:
No router / weak WiFi signal / password is not correct
Help: Wizard will help you to complete setting with one
minute.
21
Please select you current wireless network
SSID
WiFi_Burn-in
WiFi_Burn-in
WiFi_Burn-in
WiFi_Burn-in2
Help: When RSSI of the selected Wi-Fi network is lower than
15%, the connection may be unstable.Please select other available
network or shorten the distance between the device and router. If
you wireless router does not broadcast SSID, please click "Next"
and add a wireless network manually.
1.6.9.3.38.2.1.38
60:C5:A8:60:33:E1
Solar-WiFi
10.10.100.253
Disable
WiFi_Burn-in
WAP/WAP2-PSK
WiFi_Burn-in
Start Setup
RSSI
AUTH/ENCRY
WPAPSKWPA2PSK/TKIPAES 66
100
WPAPSKWPA2PSK/TKIPAES
WPAPSKWPA2PSK/TKIPAES 70
72
WPAPSKWPA2PSK/TKIPAES
Refresh
Back
www.lgresuhomemonitor.com
10.10.100.253
Admin(U):
Password:
3
1. Fill in the password of the router, then
click "Next".
2. Click "Complete".
Add wireless network manually
Network name (SSID)
Enable
Encryption method
Encryption algorithm
Please enter the wireless network passwork:
Password (8-63 bytes)
AES
Note: Case sensitive for SSID and password, Please make sure all
parameters of wireless network are matched with router, including
password.
Save success!
Click "Complete", the current configuration will take effect after
restart.
Channel
If you still neet to configure the other pages of information, please
1
go to complete your required configuration.
1
1
Configuration is completed, you can log on the Management page to
1
restart device by Click on "OK" button.
Confirm to complete?
Note:
If the Wi-Fi module fails to connect after correct passwords are entered, check
that there are not special characters used that are not supported by module.
Next
(Supported standard characters: 0~9, a~z, A~Z, supported special characters:
`~!@#$%^&*()_+-=[]\{}|;':<>? ,./'', characters not mentioned above are not
supported by default.)
21
is required.
admin
admin
Remember the password (R)
OK Cancel
WiFi-Test
WPA/WPA2-PSK
AES
Router password
show psk
Back
Back Complete
22
Next