Related Manuals for Siemens MultiRanger 200 HMI
Summary of Contents for Siemens MultiRanger 200 HMI
- Page 1 Introduction Procedure Performing a firmware update on MultiRanger 200 HMI Application examples 09\2020 AG061215...
- Page 2 Note the following: WARNING Siemens products may only be used for the applications described in the catalog and in the relevant technical documentation. If products and components from other manufacturers are used, these must be recommended or approved by Siemens. Proper transport, storage, installation, assembly, commissioning, operation and maintenance are required to ensure that the products operate safely and without any problems.
-
Page 3: Table Of Contents
Table of contents Introduction ............................4 Objective ..........................4 Equipment ........................... 4 Disclaimer..........................4 Procedure ............................... 5 Updating Firmware ......................5 Performing a firmware update on MultiRanger 200 HMI Application examples, 09\2020, AG061215... -
Page 4: Introduction
Introduction Objective The objective of this application guide is to help the user become familiar with the steps required to update the firmware on MultiRanger 200 HMI. Equipment Equipment Article No. MultiRanger 200 HMI 7ML5033-..-.. Dolphin cable adapter (DB-9 to RJ-11, 2,1b telephone cable) -
Page 5: Procedure
Procedure Updating Firmware Note • Two firmware packages are provided with MultiRanger 200 HMI, one for the sensor board and one for the HMI (display). • Downloading an HMI BS2 into the sensor will result in an error. • The HMI software has an estimated download time of 2 hours. - Page 6 – Set other communications to 8 data bits, no parity, and 1 stop bit. 9. Click Next. 10.Click Start to begin the download. 11.Once the download is complete, the following window will appear. Click OK. Performing a firmware update on MultiRanger 200 HMI Application examples, 09\2020, AG061215...