Testing And Enabling The Sensor - Bosch wLSN System Reference Manual

40 en | wLSN Devices
5.10.2

Testing and Enabling the Sensor

Test each newly discovered device during the Point Test to
enable the device. If specific point numbers are preferred, test
devices in the appropriate order.
To enable and test the water sensor and low-temperature
sensor functions, test them as described in the following
sections.
Testing and Enabling When Both Sensors are Required
1.
2.
Testing and Enabling When Only the Water Sensor is
Required
During the Point Test, test the water sensor. Refer to Table 5.17
for instructions.
The system announces "Point xx was tested."
F01U138553 | 01 | 2010.05
During the Point Test, test the low-temperature sensor
first. Refer to Table 5.17 for instructions.
The system announces "Point xx was tested."
Test the water sensor. Refer to Table 5.17 for instructions.
System Reference Guide Bosch Security Systems, Inc.
wLSN