Table of Contents
Advertisement
UV Lamp Installation (for PA31G)
IMPORTANT
Make sure the appliance is unplugged.
1. Unplug the product from the power outlet
and remove the lamp from the EPS housing.
Figure 7
IMPORTANT
Be careful when handling the lamp as the
tube is made of glass and may break.
2. Position the lamp carefully over the housing
without releasing it (Figure 8).
Figure 8
3. Connect the UV lamp to its power cable con-
nector (Figure 9).
Figure 9
4. Snap the connector into the housing and at-
tach the cable to the clip (Figure 10).
Figure 10
5. Plug the product into the power outlet and
press the "RESET UV LAMP" button as
shown in Figure 11.
Figura 11
IMPORTANT
Before the first use, it is necessary to clean
the product by following the instructions
in Chapter 6, Cleaning and Maintenance.
TIPS
The filter and lamp can be purchased by
calling the Customer Service at 3004 8778
(for capitals and metropolitan regions) or
0800 728 8778 (for other regions).
7
Advertisement
Table of Contents
