Table of Contents
Advertisement
5. How to Use
Control Panel
1
2
The key to select the water volume
1
The key to select natural water
2
The key to select cold water (a mixture of
3
natural and cold water)
The key to select cold water
4
Filter or UV lamp replacement indicator
5
(where the lamp is available in PA31G only)
Operation
When the product is powered on, all keys and
the filter or lamp (for PA31G only) replacement
indicator remain lit for 1 second and then go off.
To get water through the trigger:
1. Select the temperature with a quick tap on
the desired key.
2. Press the trigger with the cup to remove wa-
ter.
3. Remove the cup to interrupt the water outlet.
To get water using the keys:
1. Select the desired quantity of water. The
quantities of water for each portion are ap-
proximately 100 ml, 300 ml and 800 ml re-
spectively.
2. Touch the Natural, Cold or Ice-Cold key so
that the selected portion is served at the de-
sired temperature.
TIPS
To obtain approximately 1 liter of water
more quickly, press and hold one of the
3 water temperature selection keys for 3
seconds. To stop the water flow, tap on
any key again.
8
5
3
4
ATTENTION
The appliance produces a normal noise
while the cooling system is working and
when the tanks are filled.
Filter and UV Lamp Indicator
The filter and UV lamp indicator will light up
when one of these two components needs to
be replaced.
The filter and UV lamp indicator will light up
after 12 months of use, or after approximately
3000 litres of water consumed.
If the filter and/or UV lamp replacement indica-
tor is on, refer to the next chapter for cleaning
and maintenance of the product.
6. Cleaning and Maintenance
ATTENTION
Never clean the outside
of the appliance with
flammable fluids such as
alcohol, kerosene, gasoline,
paint thinner, solvents,
chemicals or abrasives
such as detergents, acids,
vinegars or products that
may leave odors.
Under normal usage conditions, installation and
quality of the supplied water, the filter should
be replaced when the saturated filter indicator
lights up (after 3000 litres or 12 months from the
start of using the filter, whichever occurs first).
Filter Replacement
Under normal usage conditions, the filter should
be replaced when the saturated filter indicator
lights up (after 3000 liters or 12 months from the
start of using the filter, whichever occurs first).
If the filter needs to be replaced before the time
described, it means that the quality of the water
supplied to the product has reduced its life but
without affecting the final quality of the water
delivered by the product. See Page 10.
Close the water supply of your house, remove
the old filter and insert the new one, open the
tap and press the "RESET FILTER" button.
These are similar to the filter installation guide-
lines on Page 6.
Advertisement
Table of Contents
