Checking The Rocker Arms And Rocker Arm Shaft - Yamaha F15B Service Manual

POWR
6. If the valve seat contact area is too wide
and situated in the center of the valve
face, use a 5° cutter to cut the top edge
of the valve seat, a 60° cutter to cut the
bottom edge to center the area and set
its width.
5
b
b Previous contact width
7. If the valve seat contact area is too nar-
row and situated near the top edge of the
valve face, use a 5° cutter to cut the top
edge of the valve seat. If necessary, use
a 45° cutter to center the area and set its
width.
5
b
b Previous contact width
8. If the valve seat contact area is too nar-
row and situated near the bottom edge of
the valve face, use a 60° cutter to cut the
bottom edge of the valve seat. If neces-
sary, use a 45° cutter to center the area
and set its width.
5-29
Power unit
60
6D450730
6D450740
b
b Previous contact width
9. Apply a thin, even layer of lapping com-
pound onto the valve seat, and then lap
the valve using a valve lapper (commer-
cially obtainable).
cC
Do not get the lapping compound on the
valve stem and valve guide.
10. After every lapping procedure, be sure to
clean off any remaining lapping com-
pound from the cylinder head and the
valve.
11. Check the valve seat contact area of the
valve again.
Checking the rocker arms and
rocker arm shaft
1. Check the rocker arms, rocker arm shaft,
and rocker arm contact surface a for
wear. Replace if necessary.
2. Measure the rocker arms inside diameter
b and rocker arm shaft outside diameter
c Replace if out of specification.
60
6D450750
6D450640
6D45F11