Checking The Gearshift Operation - Yamaha F15B Service Manual

CHK
ADJ
(For remote control model)
1. Check that the throttle cable for smooth
operation, looseness, fraying or damage.
Replace if necessary.
2. Check that the stopper 1 on the pully is
contact the stopper plate on the bracket
a when the remote control lever is in
neutral and the throttle lever is fully
closed. Adjust the throttle cable length if
necessary.
3. Loosen the locknut 2, remove the clip
3, and then disconnect the cable joint
4.
d
4. Adjust the position of the throttle cable
joint until its hole is aligned with the set
pin d on the pully.
cC
The shift/throttle cable joint must be
screwed in a minimum of 8.0 mm (0.31 in) e e .
5. Install the clip and tighten the locknut.
3-9
Periodic checks and adjustments
a 1
2
3
4
6D430225
6D430226
6. Check the throttle cable for smooth oper-
ation.
NOTE:
If the remote control cables cannot be prop-
erly adjusted at the engine side, make adjust-
ments at the remote control side.

Checking the gearshift operation

(For tiller control model)
1. Check that the gearshift operates
smoothly when shifting from neutral into
forward and reverse. Adjust the shift rod
if necessary.
R
(For remote control model)
1. Check that the gearshift operates
smoothly when shifting from neutral into
forward and reverse. Adjust the shift rod
and shift control cable joint if necessary.
2. Set the gearshift to the neutral position.
N
F
6D410120
6D430500
6D45F11