Table of Contents
Advertisement
5.3 Others
- If the 3D image sensor is in Sleep ON mode and the START button is
clicked, it is necessary to stop it by clicking the STOP button.
(The
4
second stop due to Image Capture Failure will not occur.)
- If the USB is disconnected during image output, the STOP button cannot be
clicked. (You will have to wait for the display of "Image Capture Failure" (Approx.
4
seconds).)
- If the Set button for Frequency Setting or Sleep Mode has been clicked, please
perform the next operation after checking that the value to the left of either of the
Check buttons has changed.
- When the Reset Settings button is clicked, the displays for Frequency Setting and
Sleep Mode are not updated. Therefore, please perform the next operation after
checking using each Check button that the values have changed.
- "Frame rate" indicates the display frame rate of the display software. There are
cases where it is not the specified frame rate due to the load of other applications,
etc.
5.4 Precautions
When starting up this software in Windows Vista
that the OS will not enter sleep mode.
(If the OS enters sleep mode, the PC will restart, so do not to allow the software to
switch to sleep mode.)
®
, please change the settings so
12/12
Advertisement
Table of Contents
