Bosch B12 Installation Manual

1 | Overview
The B12 Mounting Plate is required
when mounting B Series Control
Panels, the B520 Aux Power Module,
or other similar devices in D8103
Universal Enclosures, D8108A Attack
Enclosures, or D8109 Fire Enclosures.
This kit includes one B12 Mounting
Plate and one screw to secure the lock
down tab.
2
2
1
2
2
3
Figure 1.1: B12 mounting plate
Callout Description
1 Hook tabs
2 Support post
3 Lock down tab
2 | Mounting
To mount a device to the B12
Mounting Plate, complete the
following steps.
opyright
C
This document is the intellectual property of Bosch Security Systems, Inc. and is protected by copyright. All rights reserved.
Trademarks
All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly.
Bosch Security Systems, Inc. product manufacturing dates
Use the serial number located on the product label and refer to the Bosch Security Systems, Inc. website at http://www.boschsecurity.com/datecodes/.
2.1 | Attach standoffs
Snap four plastic standoffs onto the
four support posts as shown in Figure
2.1. (Standoffs provided separately with
the device being mounted.)
NOTICE!
Do not attach the
standoffs with screws at
this time.
1
Figure 2.1: Standoff attachment
2.2 | Place the device
Lay the mounting plate on a flat surface
with the standoffs facing up. Set the
device on top of the standoffs as shown
in Figure 2.2. Make sure the holes in the
corners of the device are aligned with
the openings at the top of each of the
standoffs.
Figure 2.2: Device attachment to
mounting plate
2.3 | Secure the device
Secure the device to the mounting plate with self-threading screws as shown in
Figure 2.2. (Screws provided separately with the device being mounted.)
2.4 | Securing mounting skirt in enclosure
Complete the installation by resting the hook tabs on the mounting plate hooks
within the enclosure. Secure the lock-down tab to the plate mounting hole with the
screw provided in this kit. Refer to Figure 1.1 and Figure 2.3.
Figure 2.3: Universal enclosure
Callout Description
1 Mounting plate hooks
2 Plate mounting hole
3 | Specifications
Dimensions (HxWxD) 9.25 in x 8.63 in x .5 in (23.5 cm x 21.92 cm x 1.27 cm)
1
1
2