en Basic operation
Fold the measuring aid down and
3.
click it into place.
Push in the detergent drawer.
4.
Adding detergent and care
product
Notes
¡ Please read the information in the
"Safety" → Page 4 and "Preventing
material damage" → Page 11 sec-
tions to ensure that you use the
appliance safely.
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
Requirement: Find out the optimum
dosage for "detergent and care
product." → Page 34
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 20
If required, add the care product.
3.
Push in the detergent drawer.
4.
Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Reload
▶
38
.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a If you start a programme with act-
ive oxygen, the drum lights up
after the programme starts and the
mist that is created can be seen.
a After the programme has ended,
the display shows: End.
Soaking laundry
You can soak the laundry before
washing in the appliance by pausing
the programme.
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start/Re-
.
load
To resume the programme, after
3.
the desired soaking time, press
Start/Reload
Adding laundry
Notes
¡ Please read the information in the
"Safety" → Page 4 and "Preventing
material damage" → Page 11 sec-
tions to ensure that you use the
appliance safely.
¡ If you a start a programme with
active oxygen, you cannot add any
laundry after the programme has
started.
Press Start/Reload
1.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
.
.