Sanyo VWM-900 Quick Setup Manual

Video Cassette Recorder
QUICK SETUP GUIDE
INSTALLATION - It is important that the steps are carried out in the order shown.
1
AUDIO
R
ANT.IN
IN OUT
L
VHF/UHF
IN OUT
/CATV
VIDEO
RF OUT
SETTING THE VCR CHANNELS
1 2
Press MENU, and press v v or Press V V to choose the
V V to select the TUNING SOURCE SELECT item, then
menu, then press ENTER. press b b or B B to select
TUNER.
Welcome to SANYO,
Thank you for choosing a SANYO VCR. This Quick Setup Guide will enable
you to easily install and use your new VCR. For more detailed information,
please refer to the instruction manual.
VWM-900
Connect the TV antenna cable (not
A
supplied) to the ANT.IN connector
on the back of the VCR.
Connect the supplied RF coaxial
B
cable from the RF OUT
(VHF/UHF/CATV) connector on the
VCR to the TV's antenna input con-
nector.
If your TV has audio/video input
C
jacks, connect the VCR and TV
using the audio and video cable
(not supplied). (If your TV does not
have A/V input jacks, just connect
A B
and .)
Connect the AC power cord only to
D
an AC 120V, 60Hz outlet.
3
Press v v or V V to choose the AUTO CHANNEL
SET item, then press b b or B B to set the channel.
The tuner will automatically cycle through all
available channels in the area and place them in
the tuner's memory.
2 3
When the TV is connected to When using the Audio/Video
RF OUT (VHF/UHF/CATV) cable (not supplied)
using only RF coaxial cable
Set your TV to the VIDEO mode
(supplied)
using the TV/VIDEO button on
While the VCR is turned off, your TV.
press and hold CHANNEL (V V / / v v )
Direct audio/video connections
on the front panel for more than
usually result in a better picture
five seconds (Indicators blinks as
and sound quality for tape
below). Use CHANNEL (V V / / v v ) on
playback.
the front panel to change the RF
output channel (CH 03 or CH
04).
• Select the same channel on
the TV.
Indicators on INDICATOR PANEL
(CH 03) (CH 04)
4
After the AUTO CHANNEL SET
PROCEEDING is complete, set
the TUNING BAND (TV or
CATV) on the TUNING menu.
• Remember, TV is for the air anten-
na reception, CATV is for cable or
wireless cable connection.
TUNING BAND set-
• Use CH/TRACK (v v /V V ) or CHAN-
ting is not required
NEL (V V / / v v ) on the front panel to
in this case.
cycle the VCR through the chan-
nels in memory.
VIDEO